. 3 Axial-piston wobble-plate pump
. Tempered stainless steel plungers
. Total stop system
. Self-resetting thermal cut-out
. All accessories with quick-connect design
.W ith wheel and handle for easy movement
.With detergent rate adjusting knob
How to Solve Your Customer's Problems
Q1: The machine does not start when it is energized?
A:Reason: Air is not excluded before the machine is used.
Follow the steps to solve it:
1. Connect the intake assembly first;
2. Turn on the machine and exhaust the air;
3. Connect the outlet assembly;
4. Pull the trigger and restart the machine.
Q2: Machine does not absorb water after starting?
A: Check whether the joint is leaking; Adjusting the height of the difference between the machine and the water surface of the source should not exceed 50 cm.
Q3: No water coming out after starting the machine?
A: Cleaning water intake nuts; make sure the tap is fully open and that the pipe is in an uncoiled state.
Q4: The pressure of machine effluent is very low?
A: Make sure the tap is fully open and the water pipe is controlled within 16 meters.
Q5: Tipping operation caused by machine start-up?
A: Reason: Intensively controlled blockage leads to an increase in machine power load. Put a needle through the hole of the gun.